Publicité
TO ASSEMBLE THIS KIT
To assemble this kit, you'll need the items listed below:
■ ADHESIVE:
Cyanoacrylate thin and thick, epoxy 30' and 5' adhesives.
■ TOOLS:
Knife (X-acto), Phillips screw driver (small and medium), needle tip pliers, pliers, scissors, scotch tape, masking tape, double sticking tape,
drill (bits all size set), sanding paper, ruler, ball point pen, clips, alcohol, soldering iron, piece of cloth or rags, etc.
RE-SHRINKING THE COVERING
1) Open you kit slowly and take care not to damage any parts of the kit.
Remove all parts from their plastic protective bags for inspection. Before
doing any assembly or installation of any decals, it is very important to
re-shrink or re-tighten the already applied covering. Due to the shipping
process, heat and humidity changes from different climates, the covering
may become lose and wrinkle in the sun. If you take the time to re-tighten
the covering, you'll be rewarded with a long lasting beautifully covered
model.
2) Using your covering iron with a soft sock, gently apply pressure and rub
in the covering. If any bubbles occur, your iron may be too hot.
Reduce heat and work slowly.
REMINDER
We take great care to delivering the best possible quality.
We kindly remind you that these models are not ready to fly and that the remaining work is an important part to get the model flying. For this, please,
check all glue joints and assemblies.
Safety first!
We thank you for your attention during the assembly of our kits, and wish you good and numerous flights!
TOPMODEL SAS
3) If bubbles persist, use a small pin to punch holes in the bubble to
relieve trapped air and reheat.
4) Use your heat gun with extreme caution. Take care not to apply too
much heat to one area for long periods of time. This may cause the trim
colors to over shrink and pull away leaving sightly gaps on the color lines.
The trim stripes are especially vulnerable to over shrinking.
5) Your BIDULE 55 is covered with high quality made in Germany, polyester
shrinking covering film.
In case of reparation, the Oracover® colors are the following:
White
#01621-10
●
Bright Red #01621-22
●
Silver
#01621-91
●
Black
#01621-71
●
5
Publicité
