Bushnell TRAILSCOUT 11-9600 Mode D'emploi page 9

Other Setup Notes (cont.)
3. LASER POINTER (Model 119900 Only)
The Model 11-9900 Trail Scout camera has a Laser pointer. When you mount the unit on a tree or any
other fixed surface and cannot sight from behind the Game Camera, you can use the Laser Pointer to align
the unit.
NOTE: LASER LIGHT IS POTENTIALLY DANGEROUS TO THE EYES.
THE LASER POINTER IS ACTIVATED IN THE SET-UP MODE.
DO NOT PERMIT THE LASER POINTER TO BE DIRECTED
TOWARD ANYONE'S EYES TO AVOID POTENTIAL EYE INJURY.
4. REMOTE CONTROLLER (Model 119900 Only)
The Model 11-9900 Trail Scout camera has a remote controller attachment with two functions.
Search: If you cannot locate the camera, you can press the SEARCH button,
When the Trail Scout receives the signal the unit's camera will fire the flash to help you locate it.
Snap: If you want to take a picture by remote control (without PIR activation), press the SNAP button.
14
Trail Scout 6LIM.indd 16-17
1. MOUNTING:
Mount the trail camera on the tree as shown below.
1. Screw bracket A to the tree.
2. Bolt bracket B on the back of the trail camera.
3. Match bracket B up to bracket A.
4. Then, hang bracket B over bracket A.
5. Finally, insert the padlock and lock when setup is completed.
For extra security, you can use the included cable to wrap around
the tree also.
1. Insert the end with the large lug into bracket A.
2. Then, feed the other end of the cable around the tree and back
through the bracket.
3. Tighten the adjustable locking bolt to hold the cable tightly in
place (B).
USING THE DIGITAL TRAIL SCOUT
15
1/25/05 4:25:49 PM