Bushnell TRAILSCOUT 11-9600 Mode D'emploi page 5

Switch and Setup Description
Up/Down/Enter
K1 K2 K3 K4
Up/Down/Enter
K1 K2 K3 K4 K5
6
Trail Scout 6LIM.indd 8-9
Switch Position/Setting
Switch #/Function UP CENTER
K1 (Operating On Setup
Mode)
K2 (Image Mode) Still -
K3 (Day/Night 24 Hour Day
Mode) (6AM-
6PM)
K4 (Camera Delay) 2 minutes 1 minute
Switch Position/Setting
Switch #/Function UP CENTER
K1 (Operating On Setup
Mode)
K2 (Image Mode) Still -
K3 (Lighting Mode) LED -
K4 (Day/Night 24 Hour Day
Mode) (6AM-
6PM)
K5 (Camera Delay) 2 minutes 1 minute
DOWN
NOTE (Model 11-9900 Only) : THE LASER POINTER IS ACTIVATED IN THE SET- UP MODE. DO NOT PERMIT THE
LASER POINTER TO BE DIRECTED TOWARD ANYONE'S EYES TO AVOID POTENTIAL EYE INJURY.
Off
Movie
1. K1 - Mode Switch (OFF / SETUP/ ON) :
Night
(6PM- a) Power ON (UP position): Set K1 to ON position, The LCD display will show "BUSHNELL"
6AM) for about 2 seconds, and then will prompt to input your password.
30 seconds
PASSWORD
0_ _ _
DOWN
Off
EVENT nn
IMAGE nn
Movie
Incand.
If the password entered was correct, or if the password was never previously programmed, the unit
will be enabled after a 5 minute delay.
Night
If the password is entered incorrectly 3 times the unit will be turned OFF automatically.
(6PM-
6AM)
30 seconds For mounting directions, please refer to the manual section titled "Using The Trail Scout" .
Before beginning the setup, insert 4 "D" size alkaline
batteries as indicated inside the battery compartment.
Press Up or Down key to select the first password digit of 0-9.
Note: the factory programmed default password is 0000.
Press ENTER to confirm, the cursor will move to the next digit to the right.
Repeat the process using UP, Down and Enter keys to enter your four digit
password. Press ENTER to confirm, if the password is correct the LCD will
display EVENT/IMAGE.
The LCD will rotate through the DATE\TIME\EVENT&IMAGE displays
when pressing the Up and Down keys.
SETUP GUIDE
7
1/25/05 4:25:47 PM