Automatic Preset Tuning - Yamaha AV1 Mode D'emploi

LISTENING TO A RADIO PROGRAM
2
MEMORY AUTO/MAN'L PRESET/BAND DISPLAY
VIDEO 2
TIME ADJ TIMER
/ / REPEAT
HOUR MIN
OPEN/CLOSE
PONENT SYSTEM AV–1
TUNER
CD
CENTER/REAR
/DELAY
C/R/D
ON/OFF
DSP
TEST
SLEEP
POWER AMP
1
TRACK PRESET
PRO LOGIC DSP OFF
ENHANCED MONO MOVIE
ROCK CONCERT VIDEO
DISCO HALL STADIUM
/
CD TUNER TAPE/MD VCR
PRESET
LEVEL
PROGRAM
SUBWOOFER
INPUT 1
VOLUME

Automatic preset tuning

You can also make use of an automatic preset tuning
function. By this function, this tuner performs automatic
tuning and stores stations with strong signals
sequentially. Up to 40 stations are stored
automatically in the same way as in the manual preset
tuning method on page 35.
1
Select the built-in tuner as the input source by
pressing the TUNER input selector button.
2
Press and hold the MEMORY button for about 2
seconds.
* "MEMORY" and "AUTO" will flash.
This tuner performs automatic tuning and searches FM
and AM (MW and LW for U.K. and Europe models
only) stations in that order. Received stations are
programmed to the preset station number A1, A2, A3...
A8, B1... sequentially.
When the automatic preset tuning is completed
The display shows the frequencies of the first preset
station (stored to A1).
Check the contents and the number of preset stations
by following the procedure of the section "To recall a
preset station" on the previous page.
To recall a preset station
Simply follow the procedure of the section "To recall a
preset station" on the previous page.
Notes
• The automatic preset tuning search will be performed
through all frequencies until 40 stations are stored. If
the number of received stations is less than 40, the
search will stop after searching all frequencies.
* Since FM stations are searched for first, there may
be a case that 40 preset stations are occupied by
FM stations only.
• With this function, only stations with sufficient signal
strength are stored automatically. If the station you
want to program is weak in signal strength, tune in
to it with the Manual tuning method (in monaural)
and program it by following the procedure of the
section "To store stations" on page 35.
• You can replace a preset station by another FM or
AM (MW or LW) station manually by simply following
the procedure of the section "To store stations" on
page 35.
<
For U.K. and Europe models only
•
This tuner is originally set so that only RDS stations
are searched instead of all FM stations by this
operation. (FM stations that employ no RDS network
service cannot be programmed.)
However, you can change the setting so that the unit
can program not only RDS stations but also other
FM stations. (Refer to page 43 for details.)
E-37
AUTO
MEMORY
>