Safety Precautions; Operation - Haussmann Xpert 5848003 DS1800 Manuel De L'utilisateur

Refer to Figures 9 - 13.
DESCRIPTION
The HAUSSMANN 18" Drum Sander with leg stand is
constructed of rugged cast iron and heavy gauge steel
providing stability and vibration-free operation. This
sander will accurately sand wood up to 5" thick and up
to 18" wide in one pass (36" on two passes). The drum
sander features two pressure plates to help eliminate
snipe. Feed rate is infinitely variable from 2 to 12 FPM
to accommodate various types of wood. Dust collection
system is built-in and includes filter bag.
WARNING
Operation of any power tool can result in foreign
objects being thrown into eyes, which can result in se-
vere eye damage. Always wear safety goggles complying
with United States ANSI Z87.1 before starting power tool

operation.

CAUTION: Always follow the following safety precautions.

SAFETY PRECAUTIONS

• Whenever adjusting or replacing any parts on the tool,
turn switch OFF and remove the plug from power
source.
• Make sure all guards are properly attached. All guards
should be securely fastened.
• Make sure all moving parts are free and clear of any
interference.
• Make sure all fasteners are tight and have not vibrated
loose.
• Always use the dust collection system provided with this
tool.
• Always wear eye protection or face shield.
• Make sure feed belt tracks properly. Correct tracking
gives optimum performance.
• After turning switch on, always allow drum to come up to
full speed before sanding.
• Clear the feed table of all objects (tools, scrap, etc.)
before starting tool.
• Keep your hands clear of abrasive belt and all moving
parts.
• For optimum performance, do not stall motor or reduce
speed. Do not force the work into the abrasive.
• Support long or wide workpieces with a roller stand at
table height.
• Never push a sharp corner of the workpiece rapidly
against belt. Abrasive backing may tear.
• Replace abrasives when they become loaded (glazed)
or frayed. Check belts for tightness.
• This tool is designed to sand wood or wood products
only. Do not attempt to sand metal on this tool.
OPERATION
• Do not sand pieces of material that are shorter than 6"
in length or thinner that 1/8".
• Prevent the workpiece from contacting the sanding belt
before starting the tool.
• Sand with the grain of the wood.
• Never perform layout, assembly, or set-up work on the
table when the tool is operating.
• Turn the tool "OFF", disconnect the tool from the power
source, and clean the table/work area before leaving the
tool.
• Never leave the work area when the power is "ON", or
before the tool has come to a complete stop.
OPERATING CONTROLS AND
ADJUSTMENTS
ON/OFF Switch (Fig. E)
The keyed switch is intended to prevent unauthorized use
of the sander.
1. To turn the sander ON (I) insert the yellow key (1) into
the key slot in the center of the switch.
2. Push the key firmly into the slot, then push switch to
the ON (I) position to start the sander.
3. To turn the sander OFF (O) push the switch to the
down position.
4. Remove the yellow switch key, when the sander has
come to a complete stop, by gently pulling it outward.
WARNING
Remove the switch key whenever the sander is not in use.
Place it in a safe place and out of reach of children.
WARNING
ALWAYS lock the switch OFF when the sander is not in
use. Remove the key and keep it in a safe place. In the
event of power failure, blown fuse, or tripped circuit
breaker, turn the switch OFF and remove the key,
preventing accidental startup when power comes on.
Fig. E
25
4