Haussmann Xpert 5848003 DS1800 Manuel De L'utilisateur page 23

ASSEMBLY
Before drum sander is assembled, a suitable location
should be chosen. The drum sander and stand weighs
approximately 200 lbs. when completely assembled. They
should be assembled where the tool will be installed.
• Sander needs to be set on a flat, level surface.
• Make sure there is ample room for moving the work
piece through the entire operation. There must be
enough room that neither the operator nor the
bystanders will have to stand inline while using the tool.
• Good lighting and correct power supply are also
required for a proper work area.
ASSEMBLE STAND
NOTE: Finger tighten bolts and nuts until assembly of
stand is complete. Then tighten all fasteners securely.
• Place the large and small support pieces on the floor.
Layout the pieces in a rectangle with the large and small
supports opposite to each other.
• Assemble the legs to the outside of the supports using
carriage bolts and nuts.
• Attach the large and small braces to the legs.
• Set stand upright on floor and tighten all bolts and nuts
firmly.
MOUNT DRUM SANDER TO STAND
Refer to Figure 2.
CAUTION: The drum sander is heavy. Two people will be
required to perform this operation.
• Place drum sander onto stand. Make sure that holes on
top of the stand supports are aligned with holes in
bottom of the bed of drum sander. Secure in position
using hex head bolts, flat washers and hex nuts.
Figure 2 -
ATTACH HANDWHEEL TO SANDER
Refer to Figure 3.
• Thread handle into handwheel and secure in position
with hex nut. Remove socket head bolt and washer
from shaft located on the outboard side of the bed.
Place handwheel onto shaft, making sure that the slot
in the handwheel engages the pin on the shaft. Secure
handwheel in position with bolt and washer.
Pin
Handwheel
Figure 3 -
INSTALL DUST CHUTE
Refer to Figure 4.
• Insert pan head screw through tabs on dust chute. Slide
dust chute onto end of chip exhaust. Tighten pan head
screw.
Figure 4 -
ATTACH DUST COLLECTION BAG
Place clamp over bag sleeve.
Slide sleeve with clamp over the dust port.
Secure in position by tightening clamp handle. Do not
force handle. Rotate the handle to increase the clamp
size.
22
Hex Nut
Handle
Washer
Socket Head Bolt