Maintenance - Haussmann Xpert 5848003 DS1800 Manuel De L'utilisateur

Ponceuse à tambour 18 po avec collecteur de poussière
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING
Make certain that the unit is disconnected from power
source before attempting to service or remove any
component.
CLEANING
Keep tool and workshop clean. Do not allow sawdust to
accumulate on the tool. Vacuum sawdust from drum feed
belt, roller bushings and cavities inside drum carriage.
LUBRICATION
• The shielded ball bearings in this tool are permanently
l ubricated at the factory. They require no further
ubrication.
• Periodically oil bushings on the pressure rollers and
feed table rollers.
TOOL REPAIRS
• If power cord is worn, cut, or damaged in any way, have
it replaced immediately.
• Replace worn abrasive when needed.
• Replace any damaged or missing parts. Use parts list to
order parts.
Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician. For further
information about repairs, please call the Customer ser-
vice at 1-866-599-5916 ext.2.

MAINTENANCE

REMOVING AND REPLACING DRIVE BELTS
• Loosen and remove the six socket head bolts shown
and rear panel from column (See Figure 21).
Panneau
arrière
Figure 21 -
29

Publicité

Chapitres

Table des Matières
loading

Table des Matières