Tool Maintenance; Preparation; Tool Operation - Haussmann Xpert 5848003 DS1800 Manuel De L'utilisateur

WORK PREPARATION
• Wear proper apparel. Do not wear loose clothing,
gloves, neckties, rings, bracelets or other jewelry which
may get caught in moving parts of the tool. Wear
protective hair covering to contain long hair.
• Wear safety shoes with non-slip soles.
• Wear safety glasses complying with United States
ANSI Z87.1. Everyday glasses have only impact
resistant lenses. They are NOT safety glasses.
• Wear face mask or dust mask if operation is dusty.
• Be alert and think clearly. Never operate power tools
when tired, intoxicated or when taking medications that
cause drowsiness.
WORK AREA PREPARATION
• Keep work area clean. Cluttered work areas invite
accidents.
• Do not use power tools in dangerous environments.
• Do not use power tools in damp or wet locations.
• Do not expose power tools to rain.
• Work area should be properly lighted.
• A proper electrical receptacle should be available for
this tool. The 3-prong plug should be plugged directly
into a properly grounded, 3-prong receptacle.
• Extension cords should have a grounding prong and
the three wires of the extension cord should be of the
correct gauge.
• Keep visitors at a safe distance from work area.
• Keep children out of the work area. Ensure your work
shop is child-proof. Use padlocks, master switches or
remove switch keys to prevent any unintentional use of
power tools.

TOOL MAINTENANCE

• Always unplug tool prior to inspection.
• Consult manual for specific maintaining and adjusting
procedures.
• Keep tool lubricated and clean for a safe operation.
• Remove adjusting tools. Form habit of checking to see
that adjusting tools or accessories are removed before
switching tool on.
• Keep all parts in working order. Check to determine that
guard or other parts will operate properly and perform
their intended function.
• Check for damaged parts. Check for alignment of
moving parts, binding, breakage, mounting and any
other condition that may affect tool's operation.
• A guard or any other part that is damaged should be
properly repaired or replaced. Do not perform makeshift
repairs. (Use parts list provided to order replacement
parts.)

PREPARATION

TOOL OPERATION

• Use the right tool for your job. Do not force your
tool or attachment to do a job for which it was not
designed.
• Disconnect tool when changing belt.
Avoid accidental start-up. Make sure that the switch is in
the OFF position before plugging in your tool.
• Do not force tool. It will work most efficiently at the rate
for which it was designed.
Keep hands away from moving parts and sanding
surfaces.
• Never leave tool running unattended. Turn the power off
and do not leave tool until it comes to a complete stop.
• Do not overreach. Keep proper footing and balance.
• Never stand or lean on tool. Serious injury could occur
if tool is tipped or if abrasive surface is unintentionally
contacted.
• Know your tool. Learn the tool's operation, application
and specific limitations before using it.
• Use recommended accessories (refer to part illustration).
The use of improper accessories may cause risk of
injury to the user or bystanders.
• Handle workpiece correctly. Protect hands from possible
injury.
CAUTION: Think safety! Safety is a combination of opera-
tor common sense and alertness at all times when tool is
being used.
WARNING
Do not attempt to operate tool until it is completely
assembled according to the instructions.
20