Beyerdynamic Opus 100 Mk II Notice D'utilisation page 33

3.3 Setting up
1. Push down the two snap locks on the right and left of the battery compartment and
open it. Now you can adjust the GT/MT switch
2. Make sure that transmitter and receiver are on the same frequency.
3. The LED will flash for a moment when the transmitter is switched on and indicates
3
the normal battery status. When the LED
the battery is empty or inserted incorrectly.
4. Connect the microphone to the input socket
wise. Refer to illustration below.
3.4 Adjusting Input Gain
1. Switch on the TS 100 Mk II beltpack transmitter with the ON/OFF switch
control fully anti-clockwise to minimum sensitivity.
5
2. If you have no suitable sound source, you can speak into the microphone at the maxi-
mum level you expect to use. We recommend you use the letter "U" as a spoken "U" has
a relatively good sine wave shape. Adjust the gain control
NE 100 S receiver the AF level must not show any clipping (red Audio Signal LED).
and the gain control
6
fails to flash, there is no battery inserted,
3
and fasten the plug by turning clock-
1
Microphone plug
Insert the "nose"
into the socket.
.
5
. Turn the gain
2
to the desired gain. On the
5
33