Servicing The Generator; Maintenance Table - Dometic TEC40D Notice D'utilisation

TEC40D
10

Servicing the generator

10.1

Maintenance table

!
WARNING!
Only have maintenance work carried out by specialist personnel
who are familiar with the relevant regulations. Inadequate mainte-
nance may cause serious hazards.
I
NOTE
Have the following maintenance work performed at regular inter-
vals or after the specified number of operating hours, whichever
is sooner.
Interval Inspection/maintenance
➤ Change the oil.
In the first
month or after
50 hours.
➤ Change the oil.
Every
250 hours
➤ Clean the engine's cooling system.
➤ Check the valve play and screws. Adjust the valve play and
➤ Check the air filter (chapter "Servicing the air filter" on
➤ Replace the air filter and fuel filter.
Every
500 hours
➤ Clean the oil filter.
Once a year or
every
The following must be carried out by a HATZ authorised retailer
1000 hours
or Dometic skilled personnel:
➤ Check the fuel injection pump.
➤ Check the vibration damper.
EN
tighten the screws, if necessary.
page 24).
Servicing the generator
21