8.
Press START/Pause to begin
wash cycle
Press the START/Pause/Unlock Lid button to start the wash
cycle. When the cycle has finished, the CYCLE COMPLETE
indicator will light. Promptly remove items after cycle has
completed to avoid odor, reduce wrinkling, and rusting of
metal hooks, zippers, and snaps.
Adding garment(s)
During the Fill/Sensing phase, open lid and add 1 or 2 missed
garments. Then close lid and press START/Pause/Unlock
Lid to restart the cycle. If you need to open the lid to add
a garment after this point, you must press START/Pause/
Unlock Lid and wait for the lid to unlock. This may take
several minutes if the load was spinning at a high speed. You
may hear a winding sound as the basket slows down. Then
add garment, close lid, and press START/Pause/Unlock Lid
again to resume the cycle.
NOTES:
Washer will fill with the lid open.
■
If your washer does not have a soak option, then pause
■
your washer to soak. When you are done soaking then
press Start/Pause button to bring washer out of Pause.
IMPORTANT: If lid is left open for more than 10 minutes, the
water will pump out automatically.
9.
Manually add fabric softener to
dispenser
During the final rinse, wait until the washer has completed
filling, press the START/Pause button to pause the
washer. Lift the lid and add the measured recommended
amount of liquid fabric softener. Do not use more than the
recommended amount. Close the lid and press the START/
Pause button again to start the washer.
Washer Maintenance
WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
NOTE: This washer does not include inlet hoses. See the
"Installation Instructions" for more information.
WASHER CARE
Recommendations to Help Keep Your Washer Clean and
Performing at its Best
1. Always follow the detergent manufacturer's instructions
regarding the amount of detergent to use. Never use more
than the recommended amount because that may increase
the rate at which detergent and soil residue accumulate
inside your washer, which in turn may result in undesirable
odor.
2. Use warm and hot wash water settings sometimes (not
exclusively cold water washes), because they do a better
job of controlling the rate at which soils and detergent
accumulate.
3. Always leave the washer lid open between uses to help dry
out the washer and prevent the buildup of odor-causing
residue.
Cleaning Your Top Loading Washer
Read these instructions completely before beginning the
routine cleaning processes recommended below. This Washer
Maintenance Procedure should be performed, at a minimum,
once per month or every 30 wash cycles, whichever occurs
sooner, to control the rate at which soils and detergent may
otherwise accumulate in your washer.
Cleaning the Inside of the Washer
To keep your washer odor-free, follow the usage instructions
provided above, and use this recommended monthly cleaning
procedure:
Recommended Cycle for Cleaning the Washer
Refer to the "Cycle Guide" for the optimal cycle for cleaning
the inside of the washer. Use this cycle with affresh
Cleaner or liquid chlorine bleach as described below.
Begin procedure
1. affresh
Washer Cleaner Cycle Procedure (Recommended
®
for Best Performance):
a. Open the washer lid and remove any clothing or items.
b. Place an affresh
Washer Cleaner tablet in the bottom of
®
the washer basket.
c. Do not place an affresh
detergent dispenser.
d. Do not add any detergent or other chemical to the washer
when following this procedure.
e. Close the washer lid.
f. Select the cycle recommended for cleaning the inside
of the washer.
g. Press the START/Pause button to start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted, press START/Pause once. After the cycle
has stopped, run a RINSE & SPIN cycle to rinse cleaner
from washer.
Washer
®
Washer Cleaner tablet in the
®
9