Bosch Drive Unit Mode D'emploi page 36

English–8
Status display
Depending on the operating mode shown, all status indica-
tors are not always displayed.
s1 s2
14:30
s5 s6 s7 s8
s1 Bike lights display/Charge level indicator of Nyon battery
pack
s2 Clock display
s3 Speed display
s4 North display
s5 Bluetooth®/WiFi connection display
s6 Assistance level display
s7 Charge level indicator of the eBike battery pack
s8 GPS signal display
s9 Zoom range/remaining range display
Energy supply of the on-board computer
If the on-board computer is in the holder 4, a sufficiently
charged eBike battery pack is inserted into the eBike and the
eBike system is turned on, then the Nyon battery pack is pow-
ered by the eBike battery pack.
If the on-board computer is removed from the holder 4, the
energy is supplied via the Nyon battery pack. If the Nyon bat-
tery pack is weak, a warning message appears on the display.
To charge the Nyon battery pack, insert the on-board comput-
er back into the holder 4. Note that if you do not charge the
eBike battery pack straight away, the eBike system will auto-
matically switch off after 10 minutes of inactivity. In this case,
the charging of the Nyon battery pack will also cease.
You can also charge the on-board computer via the USB port.
Open the protective cap 9. Connect the USB port 8 of the
on-board computer via a micro USB cable with a standard
USB charger (not included in the delivery) or the USB port of
a computer (5 V charging voltage, max 500 mA charging cur-
rent).
Note: If Nyon is shut down during charging, Nyon can only be
switched on again if the USB cable has been disconnected.
0 276 001 SAN | (13.7.15)
If the on-board computer is removed from the holder 4, all val-
ues of the features are saved and can still be displayed.
Without recharging the Nyon battery pack, date and time will
remain up to a maximum of 6 months. When switching back
s3 s4
on, date and time are reset after a successful GPS fix.
Note: To achieve a maximum lifespan of the Nyon battery
pack, the Nyon battery pack should be recharged every
22
km/h
6 months.
Switching on/shutting down the on-board computer
To switch on the on-board computer briefly press the On/Off
button 5.
To shut down the on-board computer press the On/Off but-
ton 5 for at least 1 second.
100 m
If no button is pressed after 5 minutes, Nyon goes into power
saving mode (back lighting off) and shuts down automatically
after a further 5 minutes.
105 km
s9
Nyon reset
If, contrary to expectations, Nyon can no longer be operated,
then Nylon can be reset by simultaneously pressing the but-
tons 1, 2, 5 and 6. Carry out the reset only if absolutely nec-
essary, as various configurations may be lost.
Battery Charge-control Indicator
The battery charge level indicator r9 (s7) displays the charge
level of the eBike battery pack. The charge level of the Nyon
battery pack can be read on the display s1. The charge level
of the eBike battery pack can also be read on the LEDs on the
eBike battery pack itself.
On indicator r9, each bar of the battery pack symbol is equiv-
alent to a capacity of approx. 20 %:
If the on-board computer is removed from the holder 4, the
last displayed battery charge level is saved.
The eBike battery pack is fully charged.
The eBike battery pack should be recharged.
!
The capacity for assisting the drive has been used
!
up, and assistance is gently switched off. The re-
maining capacity will be provided for the bike light
and the on-board computer.
The capacity of the eBike battery pack is enough
for about 2 hours of lighting. This does not account
for other consumers (e.g. automatic gearbox,
charging external devices at the USB port).
Bosch eBike Systems