Heater And Blower Replacement; Remote Battery Installation; Battery Cover - Napoleon BEF33H Mode D'emploi

6.10 HEATER AND BLOWER REPLACEMENT

A. Remove the top front and top rear panels, as illustrated in step 'B' section 6.9.
B. Unplug the wires connected to the heater and blower. NOTE: Use pliers to pinch the connector
free from the heater tabs for easier removal.
C. Remove the 6 screws that secure the heater and blower assembly to the appliance, refer to Figure 1.
Take the blower and heater assembly out of the unit.
D. Remove the 6 screws that secure the blower to the bracket, refer to Figure 2.
E. Remove the three screws located on the sides of the heater housing then remove the heater by
sliding it up and out of the housing, refer to Figure 3.
F. Remove the wires by removing the single screw from the back of the heater housing, then bend the
two tabs upwards that secure the wires in place, refer to Figure 4.
FIG. 1
FIG. 3

6.11 REMOTE BATTERY INSTALLATION

1. Turn over the remote with rear side facing up. Slide
the battery cover off the remote.
2. Place type CR 2032 battery into the remote and
reinstall the battery cover by sliding it into position,
as shown. NOTE: For ease of installation, hold
the battery while sliding the cover onto the
remote
3. Battery cover is secure onto the remote control
when a "CLICKING" noise is heard.
FIG. 2
FIG. 4
BATTERY (CR 2032)

BATTERY COVER

23
EN
REMOTE
(REAR SIDE)
W415-1299 / D /
12.03.14