3.3.4
WALL SWITCH WIRING
NOTE: Use a single pole on/off switch (not supplied) rated for minimum 15 Amps.
A.
Remove the electrical box cover plate.
B.
Feed the supply wires through the 7/8" (22mm) knock out.
C.
Connect one black wire to the black wire coming from the fi replace electrical box, connect the
other end to the wall switch.
D.
Run a wire from the wall switch to the power supply.
E.
Connect the white wire (neutral) from the power supply to the white (neutral) wire coming from
the electrical box on the fi replace.
GROUND
BLACK
(L1)
(N)
WHITE
MARRET
BLACK
WALL
SWITCH
BLACK
(L1)
WHITE
(N)
13
EN
POWER
SUPPLY
W415-1299 / D /
12.03.14