Technical Data; Installation - ZANKER KOU10301 Notice D'utilisation

Problem
The appliance does not heat up.
The oven lamp does not operate.
Steam and condensation settle on
the food and in the appliance.
If you cannot find a solution to the problem yourself,
contact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Technical data

Voltage
Frequency

Installation

Warning! Refer to the Safety chapters.
Building Under
Warning! Only a qualified and competent person
must do the installation of the appliance. If you do
not contact a qualified or competent person, the
guarantee becomes invalid if there is damage.
• Before you install the appliance, fit it with the applica-
ble hob from the table.
Type
KEV 6040
KEV 6042
Possible cause
The fuse in the fuse box is released.
The oven lamp is defective.
You left the dish in the appliance for
too long.
Maximum power
6000 W
7600 W
Do a check of the fuse. If the fuse is
released more than one time, con-
tact a qualified electrician.
Replace the oven lamp.
Do not let the dishes stay in the ap-
pliance for more than 15-20 minutes
after the cooking ends.
The necessary data for the service centre is on the rat-
ing plate. The rating plate is on the front frame of the
appliance cavity.
.........................................
.........................................
.........................................
230 / 400 V
50 Hz
Remedy
25