320 W; Installation And Setting - Meister MFS320-1 Traduction Du Manuel D'utilisation Original

must be replaced by the manufacturer
or by their customer service or a simi-
larly qualified person.
Type plate
Observe the technical specifications
detailed on the type plate! The specifi-
cations have the following meanings:
MFS320-1 Model designation
WU5456230 Article number
Bj. Year of construction
SN Series number
230-240 V~/
50 Hz Voltage and frequency

320 W

Max. power consumption
n : 6000–
0
12000 min -1 Revolutions in idle
Voluntary seal of quality (test-
ed safety)
CE mark (conformity with
European safety standards)
Do not dispose of with the
household waste!
Address of the manufacturer
Conmetall Meister GmbH · Oberkamper Str. 39
42349 Wuppertal · Germany
Safety marks
Pay attention to the safety marks! The
symbols have the following meanings:
When carrying out work in
which dust is generated,
wear a face mask and safety
goggles - do not smoke and avoid
naked flames.
MW-5456230-Bedien-2007.indd 39 MW-5456230-Bedien-2007.indd 39
Read the operating instruc-
tions!
Wear safety goggles!
Always work with a dust col-
lection system connected!
Double insulated!
7 – Installation and setting
Insert Abrasive Sheets
Switch off machine. Pull out the mains
plug. Release clamping fixtures (5) hold-
ing sanding sheet. Place sanding sheets
tightly over the sanding pad (6), making
certain that the holes (4) in pad and
patch line up. Fold over projecting paper
and clamp in place with the clamping
devices for sandings (Fig. 2).
Dust removal
The device has an integrated
dust extraction system. Plug the
supplied dust collection box (4)
into the dust extraction connection.
Preselecting the oscillation frequency
(Fig. 3)
The tool has an electronic control sys-
tem for preselection of the oscillation
frequency suitable for the material
concerned. To preselect the oscillation
frequency, turn the thumbwheel (8) to a
position between 1, lowest frequency,
– e.g. for light pre-sanding – and MAX,
highest frequency.
39
04.08.20 08:43 04.08.20 08:43