Handling Precautions - Canon SELPHY CP780 Guide D'utilisation

• If the paper is not feeding correctly into SELPHY, remove the paper cassette and any paper stuck
inside SELPHY. Then reinsert the paper cassette.
Paper jam!

• If the paper will not come out even when the power is turned off and back on, contact a Canon
Customer Support Help Desk.
• Was paper left at the back of SELPHY during printing?
There is a problem with the color ink cassette!

• Remove and reinsert the color ink cassette.
ink cassette, contact a Canon Customer Support Help Desk.
Cannot read data from memory card!

• Image types that are not supported cannot be printed.
to the original screen.
Communication error!

• SELPHY cannot connect to the mobile phone.
original screen.
No images on card!

• Check to see if the memory card is properly inserted all the way into the slot.
• Make sure you are using a supported image type.
Error!

• Turn the printer's power off and turn it on again. If the error message continues to display, contact
a Canon Customer Support center for assistance.

Handling Precautions

Do not apply excessive force to the printer. Force or impact on the printer may result in paper jams

or equipment damage.
Do not turn the power on and off repeatedly when you do not intend to print.

The initialization process consumes ink and the equivalent of several pages could be wasted.
Be careful not to spray the equipment with insecticides or volatile substances. In addition, do not

store the equipment in contact with rubber or vinyl products for long periods of time. This may cause
alteration of the casing.
Depending on the room temperature, SELPHY may overheat and temporarily stop operating. This

is not a malfunction. SELPHY will resume normal printing as soon as it cools down. Temporary
stoppages increase printing time and are most likely to occur when printing continuously, if a room
is unusually warm, if the air vents on the back of SELPHY are blocked and internal temperature is
high.
Avoid condensation on the equipment when moving it from a cold to a hot place, by putting it in

an airtight, sealable plastic bag and allow for adjustment to temperature changes gradually before
removing from the bag. In the event that condensation does form within the equipment, keep it at
room temperature until the water droplets evaporate naturally before use.
When SELPHY gets dirty, wipe the casing with a soft dry cloth.

When dust or dirt has accumulated on the battery cover or vent

color ink cassette
cleanly.
Never wipe using volatile solvents such as benzine, paint thinner, or diluted neutral solvent. They
may cause deformation or peeling of the casing.
(p. 15) before cleaning. If dust gets in through the vent, the printer may not print
(pp. 11, 15) However, if you cannot remove the color
Press the m
(p. 13)
Press the m
(p. 30)
(p. 13)
(pp. 6,
button to return
(BACK)
button to restore the
(BACK)
(p. 14)
29), be sure to remove the
33