Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.0
SAFETY REGULATIONS
FOR YOUR SAFETY
DO NOT STORE OR USE GASOLINE OR OTHER
FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY
OF THIS OR ANY OTHER APPLIANCE.
DO NOT ATTEMPT TO START THE BURNER WHEN
EXCESS
OIL
HAS
ACCUMULATED,
FURNACE IS FULL OF VAPOUR OR WHEN THE
COMBUSTION CHAMBER IS VERY HOT.
1.1
DANGER, WARNING AND CAUTION
The words DANGER, WARNING and CAUTION are used to
identify the levels of seriousness of certain hazards. It is
important that you understand their meaning. You will notice
these words in the manual as follows:
DANGER
Immediate hazards which WILL result in death or
serious bodily and/or material damage.
WARNING
Hazards or unsafe practices which CAN result in death
or serious bodily and /or material damage.
CAUTION
Hazards or unsafe practices which CAN result in minor
bodily and /or material damage.
1.2
IMPORTANT INFORMATION
WARNING
For use with grade 2 fuel oil maximum. Do NOT use
gasoline, crankcase oil or any oil containing gasoline.
WARNING
Never burn garbage or paper in the heating system and
never leave rags or paper around the unit.
CAUTION
These instructions are intended for the sole use of
qualified personnel trained in installing this type of
furnace. Installation of this furnace by an unqualified
person can lead to hazardous conditions, resulting in
bodily harm and/or equipment damage.
IMPORTANT: All local and national code requirements
governing the installation of oil burning equipment, wiring
and flue connections must be followed some of the codes
that may be applicable are :
CSA B139
ANSI/NFPA 31
ANSI/NFPA 90B
WHEN
THE
ANSI/NFPA 211
ANSI/NFPA 70
CSA C22.1
Only the latest issues of the above codes should be used,
and are available from either:
or
ENVIRONMENTAL HAZARD
Failure
environmental pollution.
Remove and recycle all components or materials (i.e.
oil, electrical and electronic components, insulation,
etc.) before unit final disposal.
2.0
2.1
This furnace is a Low-Boy and operates only in an upflow
configuration.
The appliance is shipped as a packaged unit, complete with
burner and controls. It requires a line voltage connection to
the control box (240/120 VAC, 60Hz with 3 wires plus
ground), thermostat hook-up as shown on the wiring
diagram, oil line connection(s), proper ductwork, and
connection to a properly sized vent.
The air handling capacity of this furnace is designed for
cooling air flow. Refer to Table 3 for the expected airflow at
various external duct static pressures.
IMPORTANT: If sidewall venting is not used at the time of
the installation, place a jumper between terminals # 2 and
# 3.
3
Installation code for oil burning
equipment
Installation of oil burning equipment
Warm air heating and air conditioning
systems
Chimneys, fireplaces, vents and solid
fuel burning appliances
National electrical code
Canadian electrical code
The National Fire Protection Agency
Batterymarch Park
Qunicy, MA 02269
The Canadian Standards Association
178 Rexdale Blvd.
Rexdale, Ontario M9W 1R3
CAUTION
to
follow
this
caution
INSTALLATION
GENERAL
may
result
in
Publicité
Chapitres
Table des Matières
