Napoleon HD81NT-1 Manuel D'installation Et D'opération page 37

7.1 general transmitter layout
7.2 Initializing the transmitter/battery holder for the fi rst time
A.
Install the 4 AA batteries into the Profl ame 2 battery holder, note the polarity of the batteries and insert as
indicated on the cover (+/-).
B.
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
C.
Press the reset/programming button, use a small object such as a paper clip in order to reach the button
marked PRG, as shown in the illustration below.
D.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
E.
Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
button, The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
NOTE: THE INITIALIZING PROCESS MUST BE COMPLETED WITHIN 10 SECONDS OF PRESSING THE RESET/
PROGRAM BUTTON (PRG).
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
BUTTON (PRG)
REAR SIDE
TRANSMISSION
CHILD SAFETY
LOCK OUT
LOW BATTERY
ALARM
TEMPERATURE SET POINT/ LEVEL/ STATUS
FLAME FAN AUX. OUTPUT
TRANSMITTER
7.0 operation
ROOM
TEMPERATURE
SPLIT VALVE
Blue LCD Display
On / Off Key
Temperature Key
Up / Down Arrow Key
Mode Key
FRONT SIDE
operation
EN
37
W415-2362 / A / 10.25.19