Adjust The Depth Of The Mounting Rails; Adjust The Leveling Feet - StarTech RK4236BKB Guide De L'utilisateur

Adjust the depth of the mounting rails

The mounting rails come preinstalled in the enclosure cabinet. Both the front and back
sets of mounting rails can be adjusted independently in 3/4 inch (20 mm) increments
to accommodate different sizes of equipment.
Warning! Do not attempt to adjust the mounting rails when equipment is installed in
the enclosure cabinet. Remove the equipment first before you adjust the mounting
rails.
1. Each of the mounting rails is connected to the enclosure cabinet with a screw and
cage nut in the upper and lower corners of the mounting rail. Use a Phillips type
screwdriver to remove the screws and cage nuts from the mounting rails.
2. Install the cage nuts at the desired depth.
3. Slide the mounting rail to the depth of the cage nuts and use a Phillips type
screwdriver to install and tighten the screws that you removed in step 1.

Adjust the leveling feet

Warning! Remove any equipment from the enclosure cabinet before you adjust the
leveling feet.
The enclosure cabinet ships assembled with both casters and leveling feet installed.
• To adjust the leveling feet, use the provided hex key to turn the screws located in
each of the four corners on the inside of the enclosure cabinet.
Caution! Make sure that all four of the leveling feet are set to the same height before
you start to load equipment into the enclosure cabinet.
Instruction manual
6