Table des Matières
Publicité
7. Run the monitor cable through the cable-management hook on the bottom of the
mounting plate. (figure 5)
figure 5
Cable-management hook
Adjust the angle of the monitor
To position the monitor, do either of the following:
• Use the 5 mm hex key to loosen the screw in the monitor mount. Move the monitor
and then tighten the screw again. (figure 6)
• Use the 4 mm hex key to adjust the swivel joints in the display arm. (figure 6)
figure 6
5 mm hex key
4 mm hex key
Instruction manual
8
Publicité
Table des Matières
