Bartscher 600 Série Mode D'emploi page 44

 Check the condition of the power cable;
The gas tap should be lubricated but this is a difficult operation and not very reliable; therefore

it is advisable to substitute it;
ATTENTION! Before carrying out any substitutions, make sure that the appliance is
disconnected from the electric mains and that the gas cut-off valve is closed.
Safety cock (fig. 9, page 4)
To replace the safety cock, it is necessary to remove the knobs, the drip pan and the control panel,
as shown in figure 9. Next, it is necessary to unscrew the pipe union of the pipe which goes to the
burner, the pipe union of the pilot burner pipe, the thermocouple and finally, the clamp of the ramp.
Then substitute the part.
Thermocouple and the igniter plug (figg. 9, 14, page 4)
To replace the thermocouple and/or the igniter plug of the griddle plate, it is necessary to remove
the knobs, the drip pan and the control panel (fig.9, page 4). Then remove the support bracket (8) of
the thermocouple and igniter plug; unscrew the fixing union (10) of the thermocouple (9) to the
bracket; unscrew the union of the thermocouple on the valve.
To replace the igniter plug it is necessary to unscrew the fixing union (12) of the igniter plug (11) to
the bracket (8) and disconnect it from the feeder. Then change the part and replace the parts
previously removed the other way round.
Heating elements (figg. 15, 16 pages 5, 6)
To replace the heating elements, it is necessary to remove the knobs, the drip pan and the control
panel; remove the nuts (1 fig. 15) fixing the hotplate to the work top; lift the part and tilt it. Then
unscrew the fixing bolts of the covering; remove the covering itself (2), the insulation (3) and the
casing (4). Disconnect the heating element (5) to be replaced and take it out. Then change the part
and replace the parts previously removed the other way round.
Electric components of the electric griddle plates
For the replacement of the selector, of the thermostat, of the safety thermostat, of the lamps, and of
the main terminal board of the electric griddle plates, it is necessary to unscrew the fixing screws of
the control board (fig. 9 at page 4) and remove it. Then disconnect the electric cables of the
component and replace it. After the replacement, connect the electric cables following the
instructions of the wiring diagram.
Information for electrical and electronic devices used in EU countries
According to EU directives, devices marked with the following symbol
of together with normal household waste.
To dispose of your used device, please use the locally available differentiated collection system or
consult your retailer when you buy an equivalent product.
By actively using the provided collection systems, you are contributing to the reuse, recycling and
enhancement of electrical or electronic devices and protecting the environment and health.
SUBSTITUTING COMPONENTS
Pag. 43/58
, may not be disposed