Stroller Operation; Unfolding And Folding - BOB REVOLUTION DUALLIE FLEX Guide De L'utilisateur

BOB Gear by Britax
Rear Wheel Removal
1� Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
2� Remove Wheel
Raise the wheel a few inches off
the ground, pull the release lever,
and pull the wheel out of the rear
wheel attachment bracket.
Front Wheel Installation
1� Remove Quick Release Axle
From Front Wheel
Unscrew the nut from the quick
release axle and remove the axle
from the front wheel.
2� Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 9.
6
3� Insert Front Wheel
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with the holes in the fork blades.
4� Insert Quick Release Axle
Insert the quick release axle into
the fork and through the wheel
hub, then install the tension
adjusting nut to the opposite side.
5� Tighten Tension Adjusting Nut
With the quick release lever in
the FULLY OPEN position, hand
tighten the tension adjusting nut
until secure.
Tension Adjusting Nut
6� Close Quick Release Lever
Lift up on the quick release lever
to lock into the FULLY CLOSED
position. When properly closed,
the quick release lever will be
parallel to the fork blade and
pointing up.
FULLY CLOSED
Fork Blade
FULLY OPEN
IMPORTANT: It takes
considerable force to securely
close the quick release lever. If
you are able to completely close
the quick release lever without
wrapping your fingers around
the fork blade and the quick
release lever does not leave a
visible imprint in the palm of
your hand, or the quick release
lever spins freely on the quick
release axle, the tension is not
adequate. Return the lever to the
FULLY OPEN position and turn
the tension adjusting nut a quarter
turn clockwise, then repeat the
closing process.
If the quick release lever will
not lift into the FULLY CLOSED
position, return the lever to the
FULLY OPEN position and turn
the tension adjusting nut a quarter
turn counterclockwise. Repeat the
closing process.
Front Wheel Removal
1� Open Quick Release Lever
Move the wheel's quick release
lever from the locked or FULLY
CLOSED position to the FULLY
OPEN position.
2� Remove Quick Release Axle
Loosen the tension adjusting nut
and remove the quick release axle
from the front wheel and fork.
3� Remove Front Wheel
Raise the front wheel a few inches
off the ground and pull the wheel
out of the front fork.
REVOLUTION DUALLIE User Guide

Stroller Operation

Unfolding and Folding

Unfolding the Stroller
1� Lift Red Frame Release Handle
Keep tires on ground as stroller
swing arm begins to swing open.
NOTE: Stroller swing arm will
swing open and snap into an
open and locked position.
2� Rotate Handlebar
Lift handlebar up and back until
it snaps into locked and upright
position.
7