ResMed Swift LT-F Mode D'emploi page 6

WARNING
Do not use aromatic-based solutions or scented oils (eg, eucalyptus or
essential oils), bleach, alcohol or products that smell strongly (eg, citrus)
to clean any of the system's components. Residual vapours from these
solutions can be inhaled if not rinsed thoroughly. They may also damage
the system, causing cracks.
CAUTION
If any visible deterioration of a system component is apparent (cracking,
crazing, tears etc.), the component should be discarded and replaced.
Daily/After Each Use
Handwash the separated mask components (excluding headgear) by
gently rubbing in warm (approx. 30°C) water using mild soap or diluted
dishwashing detergent for one minute. Rinse all components well with
drinking quality water and allow them to air dry out of direct sunlight.
Weekly
Handwash the headgear, soft wraps and tube retainer in warm (approx.
30°C) water using mild soap or diluted dishwashing detergent. Rinse well
and allow them to air dry out of direct sunlight.
Reprocessing your Swift LT-F between Patients
The Nasal Pillows System should be reprocessed when used between
patients. Cleaning, disinfection and sterilisation instructions are available from
the ResMed website, www.resmed.com/masks/sterilization.
If you do not have Internet access, please contact your ResMed
representative.
Storage
Ensure that your Swift LT-F is thoroughly clean and dry before storing it for any
length of time. Store the mask in a cool dry place out of direct sunlight.
Disposal
The Swift LT-F does not contain any hazardous substances and may be
disposed of with your normal household refuse.
5