Installation And Connection - Bartscher 700272 LN Mode D'emploi

5.2 Installation and connection

Preparation of the device
NOTE!
Two people are needed to set up the device!
•
Remove the package material from the device.
•
Remove the device from the styrofoam base. Remove the adhesive tapes.
Caution! The refrigerator is equipped with the screwed door handle.
In order to avoid breaking of the handle do not use it for lifting and moving the
device.
•
During installation lift the front side of the device slightly which facilitates its moving
to the destination place due to castors.
•
Open the refrigerator door. Remove the sealing elements above the refrigerator door.
NOTE: When the refrigerator door is opened, the small red element falls
out, which is used only for the transport purposes.
•
Remove red adhesive tapes used
only for the transport purposes.
•
Place the bumpers (1) in the guides (2)
of the upper part of the back wall (fig. 4).
•
Remove red elements from the shelves
(fig. 5) used only for the transport
purposes.
•
Remove all package material.
The package material should be removed
in the environment-friendly way.
fig. 4
fig. 5
- 33 -