Installation And Connection - Bartscher 200 LN Mode D'emploi

5.2 Installation and connection

Preparing the device for use
NOTE!
Two people are needed to set the device up!
•
Remove packing material from the device.
•
Remove the device from its foam base. Remove all packing tape. If there is any
Styrofoam between the rear wall of the device and the condenser, remove it as well.
Attention! The deep freezer is equipped with a rotating door handle. To avoid
dislodging the handle, do not use it to lift or to move the device.
•
During setup, the front portion of the device can be tilted slightly backwards in order
to make it easier to transport the device on wheels to another location.
•
Remove the red adhesive tape strips which are only necessary during transport.
•
Attention: after opening the door a small, red element will fall out – this is only
needed during transport.
•
All packing materials should be turned over for recycling.
•
Remove the two spacers (1) and place
them in the guides (2) at the top of the
device's rear wall (fig. 1).
Setup
•
Place the device in a dry area with good ventilation.
•
Never place the device on a flammable surface.
•
Do not place the device near an open flame, electric oven or other source of heat,
as well as in direct sunlight. Heat may damage the device's surface and lead to
reduced efficiency.
•
To avoid damage to the compressor, during transport and setup do not tilt the deep
freezer further than 45° . Be careful in handling th e condenser and door of the device
as damage to either element will result in problems using the device.
CAUTION!
Do not place nor use the device in unheated spaces nor on a balcony!
- 30 -
Fig. 1