Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. Press the „ENTER" button 2; the maximum value
after period and „max mem" begin to flash.
9. Press the „ENTER" button 2 for 3 seconds to
delete the maximum value.
10. Press the „ENTER" button 2; the total maximum
value and „max mem" begin to flash.
11. Press the „ENTER" button 2 for 3 seconds to
delete the maximum value.
12. Press the „ENTER" button 2 to complete the
programming procedure.
Note: Every time the alarm is activated by pressing
the „ ON/OFF" button 5 the bell icon appears
on the display.
READING AND DELETING DATA MEMORY
1. Press the „HISTORY" button 6.
2. Use „" 3 and „" 4 to choose the data sets you
wish to see. The recording time is displayed in the
date and time field.
3. Press the „ENTER" button 2; „CLE" appears in the
date field and the memory icon begins to flash.
4. Press the „ENTER" button 2 to delete the memory.
Note: For data analysis (History) over a lengthy period
up to 4,080 data sets can be evaluated in the station
itself. They are saved in an EEPROM. In the event of a
power failure the data remains intact. If the internal data
memory is full, it is always the oldest data sets that are
overwritten by new data (circular memory). The station
automatically saves a data set for
analysis every 30 min. The recording
interval can be customised from 5 mi-
nutes to 4 hours in the PC software.
RESETTING BASE UNIT TO
FACTORY SETTINGS
With the base unit in normal display
mode, press the „" button 3
for 20 seconds to delete all your
settings and restore the factory
settings.
313531__Funk-Wetterstation_Manual_180223.indd 21
PC CONNECTION, SOFTWARE
Many of the weather station parameters can also be
customised easily on your PC. The weather data can be
presented as a graph or exported, to a website for example.
The storage capacity for the number of data sets is only
limited by the PC storage medium.
SYSTEM REQUIREMENTS
The software runs on Windows 2000, Windows XP,
Windows Vista, Windows 7, Windows 8, Windows 10
and MAC OS.
Note: The operating instructions below also apply to
MAC OS.
INSTALLING THE SOFTWARE
1. Insert the CD-ROM in your disk drive.
2. In administrator mode (admin password) launch the
„setup.exe" file on the CD-ROM and follow the
instructions displayed.
3. Select a menu language.
4. Select a storage location.
5. Link your PC to the station with the USB cable.
6. Reboot the computer.
7. Launch the program in administrator mode so that all the
graphic display functions operate properly.
8. The data sets are imported from the weather station.
Note: Depending on the number of data sets to be
imported, the program may run more slowly. Have the
program import all the data sets first in order to prevent
the possible error message „read weather data fail" if
you want to switch to setup mode.
The current weather data and the weather station settings
now appear. You will also see the number of data sets
imported and the status of the USB link.
21
Fig. 6
English
26.02.18 09:14
Publicité
Table des Matières
