Moon Phase; Maintenance And Care - UNITEC Climate E0316 Manuel De L'utilisateur

MOON PHASE

The moon phases (O) are displayed according to the
calendar.
New moon
First quarter
Waxing half moon
Second quarter
Full moon
Third quarter
Waning half moon
Last quarter
SNOOZE
Press the „SNOOZE" button 7 to interrupt the
alarm for 5 minutes. Icons Z
period. Press any button apart from „SNOOZE" to
complete the snooze function.
WEATHER FORECAST
The device forecasts weather conditions for the next
12 - 24 hours based on changes in atmospheric pres-
sure. The catchment area covers approx. 30 – 50
km. The weather forecasts have an accuracy of 70%
– 75%. Since weather conditions cannot be forecast
with 100% accuracy, we cannot be held responsible
for any losses that are caused by incorrect weather
forecasts.
Sunny
Partially cloudy
Cloudy
Rain (Snow)
Cloudburst/Snowstorm
313532__Funk-Wetterstation_Manual_180410.indd 13
and  flash during that
Z
Important: The device must be in operation for at
least 12 hours to record a pressure trend. The wea-
ther icons (P) are displayed on the basis of that trend.
Note: Places with various geographical situations,
e.g. inland areas, windy valleys or coastal regions,
have different weather forecasts. Your particular
weather forecast (P) may be different in such areas.
INDICATORS FOR TEMPERATURE AND
HUMIDITY TRENDS
If the values for temperature and humidity have
changed, 4 small arrows indicate the tendency (K):
Rising, constant or falling.

MAINTENANCE AND CARE

Only clean the device with a soft cloth. If there is
heavy soiling, the cloth can be moistened slightly.
Never use detergents that contain solvent.
Make sure no moisture gets inside the device. As
regards the outdoor sensor, check to make sure the
battery compartment cover is fitted properly, espe-
cially when you have changed the batteries.
If dust has accumulated in the opening of the sensor
cover, it can be removed with a vacuum cleaner.
DISPOSING OF OLD EQUIPMENT
At the end of its life, do not dispose of this product
in the normal household waste. Take it to a recycling
collectionpoint for electrical and electronic equip-
ment.
This is indicated by the symbol on the product, the
operating instructions or the packaging.
DECLARATION OF CONFORMITY
We, Tegro AG (Ringstrasse 3, 8603 Schwerzenbach,
Switzerland), declare with sole responsibility that this
product conforms to the basic and other relevant
requirements of Radio Equipment Directive 2014/53/
EU. To request the Declaration of Conformity please
contact: info@tegro.ch
13 13 English
24.04.18 09:25