Starting Up; Assembling And Setting Up The Light - MELINERA HG00374A Instructions D'utilisation Et Consignes De Sécurité

Starting up

Q
Assembling and setting up the light (Fig.
Q
A)
j I nstall the light in accordance with Fig. A.
P lace the light with the assembled rods into the ground
j
(lawn, flower bed, etc).
Note: Ensure that the product stands firmly in place. Do not
use any force when assembling or setting up the product, e.g.
hammer blows. This damages the product.
Note: For the best results, put the light in a place where the
solar cell
4
Do not put the light under bushes, trees, canopies etc. as this
reduces the incidence of incoming sunlight. Position the lamp in
such a way that the solar cell
Note: Make sure that the solar cell
source of light such as street or garden lighting as the light will
otherwise not switch itself on automatically when it starts to
get dark.
S witch the AUTO / OFF switch
j
casing into the AUTO or OFF position to switch the lamp
5
on or off.
Note: The LED light bulb
tween the colours red, blue and green.
Note: Switch the lamp off (OFF position) if the lamp will be
in the dark for any length of time (e.g. when transporting it
with a rechargeable battery
not satisfactory due to a very short incidence of light.
O pen the solar casing
j
10 GB/IE
is exposed to direct sunlight for as long as possible.
2
into a horizontal position.
5
is not covered or in the shade.
4
is not near another
4
on the bottom of the solar
11
will automatically switch be-
inserted) or the burn time is
9