Preparing For Use; Installing The Product; Setting Up The Product; Replacing The Rechargeable Battery - MELINERA HG03854B Instructions D'utilisation Et Consignes De Sécurité

vertical angle of light at temperatures above the freezing point
is ideal. The rechargeable battery
mum capacity until after several charge and discharge cycles.

Preparing for use

Note: Remove all packaging materials from the product.

Installing the product

Install the product in accordance with Figures A, C, D:
1. Rotate the solar cell housing
lamp shade
2. Move the ON / OFF switch
switch the light on.
3. Insert the solar cell housing
tighten by turning it clockwise.
4. Place the lamp shade
5. Take out the ground stake
it into the pole
Fig. C).
6. Your product is ready for use (see Fig. D).

Setting up the product

Insert the assembled product far enough into the ground
(lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance at all
times. Do not use any force when assembling or setting-up
the product, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set the product
up in a place where the solar cell will get direct sunlight
for as long as possible.
Make sure that the solar cell is not influenced by any
other source of light such as yard or street lighting as
otherwise the light will not come on in twilight.
The light automatically switches on in twilight conditions and
off again when normal outdoor lighting conditions return.

Replacing the rechargeable battery

The rechargeable battery should be replaced every
12 months to ensure optimum performance.
(see Fig. A).
2
1
on to the pole
2
4
with the tip facing downwards (see
3
does not achieve maxi-
8
anticlockwise out of the
1
into the ON position to
5
into the lamp shade
.
3
from the pole
and
2
and insert
3
GB/IE/NI 9