ASCOM Office 40 Mode D'emploi page 115

Using the extended-feature functions
Enquiry call
You are conversing with one party and wish to make a brief call to another party while
holding the existing connection.
Enquiry–call
Note If you press the wrong key or replace the handset after terminating the enquiry
call, a continuos ringing tone is emitted for around 10 seconds to remind you that
the first call is stil connected. If you lift the handset during this time you will
return to the first call.
Brokering
To switch between the first call and the enquiry call.
2nd–conversation
Transferring the call
After initiating an enquiry call you wish to connect the two call partners.
Conference
After initiating an enquiry call you wish to set up a conference together with your original
call partner.
Conference
Note Don't worry! When you are setting up a conference call, none of your call
partners will be disconnected. The connections will only be disconnected if the
END key is pressed or if the handset is replaced!
20317861en_bat_a0
Enter the number for the enquiry, press the
Foxkey under "Enquiry_call".
At the end of your enquiry call press the END key.
END
Press the Foxkey under "2nd_conversation".
Replace the handset.
Press the Foxkey under "Conference"
7