Troubleshooting; Troubleshooting Under Cooked Eggs; Troubleshooting Egg Rings - Antunes Egg Station Mini Mode D'emploi

Troubleshooting

Problem
The egg station fails to op-
erate and the control panel
lights fail to signal on
The egg station fails to heat
Eggs do not cook
properly
Eggs stick to the platen
Eggs stick to the egg rings
Troubleshooting Under cooked
Eggs
1. Level the egg station. (See "Leveling
the Unit" on page 5)
2. Do not use cold water in trough. Use
room temperature water. Warm water
is preferred.
3. Ensure trough is filled to the tup and
not over/under-filled.
4. Ensure Start button is pressed
promptly after lid is closed and trough
is filled.
5.
Yolks must be broken with spatula.
6. Clean the grill surface after each cook-
ing cycle.
7. Use the correct amount of butter/oil on
grill surface.
8.
Confirm ready light is solid green prior
to starting another cooking cycle.
9.
Check grill temperature according to
the section titled Checking Grill Platen
Temperature in the Maintenance sec-
tion of this manual.
10. Regularly check the holes in the
trough to ensure there are no clogs.
P/N 1011587 Rev. C 11/20
Possible Cause
No power/low power
Inoperable electrical outlet
Inoperable power switch
Inoperable power cord
Loose connections
Loose connections
Inoperable platen
Low voltage
Inoperable Hi-limit thermostat
Inoperable thermocouple
Inoperable solid state relay
Incorrect amount of water added to the
trough in the cover
Loose connections
The egg station or the table is not level
Dirty platen
Insufficient butter being used
Insufficient butter being used
Dirty egg rings
Inoperable egg rings

Troubleshooting Egg Rings

Egg Ring Replacement depends on us-
age but in general, Egg Rings should be
replaced yearly. If eggs begin to leak out of
the Egg Rings:
1. Inspect the Egg Rings for damage
regularly. Clean the unit and flip the
Egg Rings 180° degrees or replace
the Egg Rings if required.
2. Egg Rings should be installed in the
Egg Rack so they can move up and
down to ensure they are flush against
the grill surface. If the Egg Rings do
not move freely up and down within
the Rack, remove the Egg Ring and
reshape it to its normal form, and rein-
stall. Replace the Egg Ring if required.
3. The Egg Rings should sit flush against
the grill surface and hold the egg
inside the Egg Ring while cooking.
Review the previous section for guid-
ance. Inspect the Egg Rings for dam-
age. Flip or replace as required.
Corrective Action
Verify that the power is on and the power cord
is locked into place; check the main circuit
Plug the power cord into a different outlet with the same
amperage rating
Contact Antunes Technical Service at +1-877-392-7828 (toll
Contact Antunes Technical Service at +1-877-392-7828 (toll
Fill the trough in the cover with water before starting the
Contact Antunes Technical Service at
+1-877-392-7828 (toll free)
Level the table and the egg station as necessary
Clean the platen
Refer to the Operating section of this manual
Refer to the Operating section of this manual
Clean the egg rings (do not use abrasive scrubbing pads)
Replace the egg rings
9
breakers
free)
free)
time cycle
®