Installation; Unpacking; Leveling The Unit - Antunes Egg Station Mini Mode D'emploi

Installation

Unpacking

1. Remove egg station and all packing
materials from the shipping carton. If
any parts are missing or damaged,
contact Antunes Customer Service
IMMEDIATELY at +1-877-392-7856
(toll free).
2.
Remove the information packet.
3. Remove all packing materials and
protective coverings.
4.
Wipe all surfaces of the egg station
with a hot damp cloth. Do NOT use a
dripping wet cloth. Wring it out before
use.
5. Clean the egg rings, egg rack, top
cover, scrap bracket and tray in hot,
soapy water. Rinse in clear water and
allow to air dry.
6. Reassemble the egg station.
7. The egg station must be level before
use.

Leveling the Unit

Use a level and adjust the front feet if
necessary.
If a level is not available, pour a small
amount of water onto the center of the cool
grill surface. If it is level, the water will pool
in the middle.
If the water drains away from the middle,
level the egg station by adjusting the legs
as necessary turn clockwise to lower that
corner, counter-clockwise to raise it, as
shown in this figure.
Figure 1. Leveling the Egg Station
NOTICE
Failure to level the table and/or unit
may result in unevenly cooked product.
P/N 1011587 Rev. C 11/20
6 ring Egg
Rack shown
5
Figure 2. ESM-600
Egg Ring
Tray Bracket
Figure 3. Components
Top Cover
Egg Rack and Rings
Grill Surface
Scrap Tray
®