Össur FLEX-SYMES SLPOXYYO Mode D'emploi page 9

Table des Matières

Les langues disponibles

FLEX-FOOT SOCK FCX63006/7

To protect the cover and avoid noise, a Flex-Foot sock is fitted over the

foot module before installing the cover. The sock should be loose in the

heel area.

SHOEHORN CM100068 (Figure 9)

When removing and installing the cover, use shoehorn to avoid damage

to foot or cover.

MAINTENANCE

The FLEX-SYMES can be used in water but warranty terms only apply if

the following conditions are met:

• The foot is cleaned with tap water after use in salt water and / or

freshwater.

• Immediately following contact with water, take the the foot cover off

the foot and dry thoroughly.

• The components used with the foot need to be waterproof as well.

LIABILITY

The manufacturer recommends using the device only under the specified

conditions and for the intended purposes. The device must be

maintained according to the instructions for use. The manufacturer is

not liable for damage caused by component combinations that were not

authorized by the manufacturer.

CE CONFORMITY

This device meets the requirements of the 93/42/EEC guidelines for

medical devices. This device has been classified as a class I device

according to the classification criteria outlined in appendix IX of the

guideline.

COMPLIANCE

This component has been tested according to ISO 10328 standard to two

million load cycles. Depending on the amputee's activity this

corresponds to a duration of use of two to three years. We recommend

carrying out regular yearly safety checks

ISO

- "P" - "m"kg *)

Body mass limit not to be exceed!

For speci c conditions and limitations of use see

manufacturer's written instructions on intended use!

have been adapted adequately on the basis of the specified load level.