Össur FLEX-SYMES SLPOXYYO Mode D'emploi page 8

ASSEMBLY (Figure 6, 7 & 8)
• Position circular alignment wedges according to dynamic alignment.
• Assemble and torque center bolt using Loctite 410, see table 2.
Table 2: Torque Specifications for central bolt.
Category
1 – 6
7 – 9
Note: Applies to all sizes.
• Guided by the positioning hole, drill a hole trough the circular
alignment wedge/s and the socket adapter. Tap threads for the anti-
rotational bolt, see table 3 for specifications.
Table 3: Thread specifications for anti-rotation bolt.
Sizes
22 – 27
28 – 30
• Assemble, using Loctite 410, anti-rotation bolt
(CM130326/7) and anti-rotation washer
(SLX30055/6) to secure the alignment.
Torque to 10 Nm, 8 ft-lb.
• Position the heel divider (CM140003) in the posterior slot of the
splitted heel part, see fig. H. Bolt the heel to the foot module and
torque to specifications, see table 4, using Loctite 410. Make sure
there is no interference with the central bolt head when the heels are
compressed. To secure the position of the heel divider a drop of
instant adhesive can be used on one side.
Table 4: Torque specifications for heel attachment bolts.
Category
1 – 6
7 – 9
Note: Applies to all sizes
IMPORTANT
It is important that the torque specifications are met.
COSMETIC COVER FCA0XXL/R
The foot section may be covered with the anatomical foot cover. Add
"BR" to the part # for brown cover.
The Foot cover may need some trimming if the socket does not fit into
the foot cover. A foot cover attachment cannot be used for FLEX-SYMES.
Torque
40 Nm (30ft-lbs)
60 Nm (44ft-lbs)
Drill ø [mm]
5.0
6.8
Bolt diameter [in]
1/4
5/16
Tap
M6 x 1.0
M8 x 1.25
Torque
14 Nm (10ft-lbs)
28 Nm (21ft-lbs)
8