Electronic Functions - Preliminary Operations; Turning On; Top Model; Tt Model - Jacuzzi frame Manuel D'utilisation Et D'entretien

Electronic functions -
preliminary operations

Turning on

Check that the hydraulic and electrical output are function-
ing and connect the power to the shower enclosure: an equip-
ment check procedure is started and the steam generator is
automatically rinsed (in models with displays, some information
about the operating software is displayed, after which the time ap-
pears).
During this phase, which lasts a couple of minutes, no func-
tion may be activated.
After this preliminary check, the keys (and the display) are il-
luminated with a white light with reduced intensity:

TOP model

Press the "on/off" key and then it will be possible to activate
the electronic functions (refer to the relative chapter).
If after pressing the "on/off" key a few codes appear on the
display (AL_...), this means there is an error (refer to the "Errors"
chapter).
Do not press the "on/off" key if you want to set or adjust
the time and/or the display contract (refer to the relative para-
graphs); if you press the "on/off" key before adjusting the time and/
or the display contrast, it will be necessary to turn the shower unit
off and then on and wait again for the display to return to the status
shown in the figure.

TT model

Press any key to activate the electronic functions (refer to the
relative chapter).
If after pressing the key some LEDs and/or keys start to flash,
this means there could be an error (refer to the relative chapter).

Setting/adjusting the time

These operations may only be carried out if the scale removal
cycle is not activated and/or after the shower unit activation phase
is complete (refer to the relative paragraph).
If the time is not set, it will be reset each time the shower unit
is turned on.
Press in order the keys "<" and ">" within 5 seconds of each
other: the hour will start to flash.
1
Press the keys "<" or ">" to decrease or increase the displayed
value; then press the "on/off" key to store it and then adjust the
minutes, following the same procedure.
At this point, the display contrast can be adjusted (refer to the
relative paragraph).
Otherwise, press the "on/off" key again to activate the elec-
tronic functions (refer to the relative chapter).
If after pressing the "on/off" key a few codes appear on the
display (AL_...), this means there is an error (refer to the "Errors"
chapter).

Adjusting display contrast

These operations may only be carried out if the scale removal
cycle is not activated and/or after the shower unit activation phase
is complete (refer to the relative paragraph).
Press in order the keys "<" and ">" within 5 seconds of each
other: the hour will start to flash.
49
2