Turkish Bath; Top Model - Jacuzzi frame Manuel D'utilisation Et D'entretien

Turkish bath

T
he Turkish bath is enjoyable and beneficial at any time of the
year, both in winter to prevent discomfort related to the com-
mon cold and to provide relief to muscles, as well as in summer to
lower body temperature and promote tanning (or to enhance it).
The Turkish bath also stimulates the replenishment of water in
the body, keeping the respiratory passages unobstructed by keep-
ing them moist; it also promotes vasodilation and, as a result, im-
proved skin nourishment.
This activation of this function depends on the number
of Turkish baths already carried out: if this is between 20
and 30 and you press the respective key, the water-pitcher
symbol on the display will flash for a few seconds (in the TT
model, the "Turkish bath" key will flash). This indicates that a
scale removal cycle should be carried out (the "Turkish bath"
function is still available).
If it is impossible to activate the function (in the TOP
model, pressing the "Turkish bath" key again, the control
panel will return to the "awaiting instructions" mode, where-
as in the TT model, the "water-pitcher" key will light up) indi-
cating that a scale removal cycle must be performed.
Please note that if the function is interrupted during the first
5 minutes of steam production, the system does not consider
this time as a complete Turkish bath session, and therefore the
number of "Turkish baths" carried out will be not increased.
Refer in any case to the "Scale removal cycle" chapter.
It is possible to use scented sticks or essential oils to perfume
the steam bath: open the dispensers and insert the sticks (or
some drops of oil); then reclose the dispensers, pressing them
down until they lock.
The single-dose packages of scented sticks are available from
Jacuzzi® Service Centres; we advise cutting the sticks into two piec-
es, and placing one in each dispenser.
A
A
A
Make sure that the waterfall, the whirlpool jets and/or the
scale removal cycle are not active; also make sure that the con-
trol panel is in the "awaiting instructions" mode (refer to the
"Activating the electronic functions" chapter).

TOP model

Press the "Turkish bath" key, the following configuration will ap-
pear on the display:
2
3
If a few seconds pass without pressing any key, the control
panel will return to the "awaiting instructions" mode and then
"stand-by": press the "on/off" key to reactivate the control panel
and then the "Turkish bath" key to activate the desired function.
Make sure that the steam symbol has been selected (the
cloud on a white background, as shown in the figure); if not, use
keys "<" or ">" to select the symbol.
Then press the "on/off" key to access the function menu.
If there are errors that do not permit the function to be acti-
vated, these are shown on the display with codes:
AL1_1
AL1_2
AL3
....
Press the "on/off" key again to return to the previous point;
then refer to the "Error condition" chapter and contact a Jacuzzi®
service centre if necessary.
59
10/30
2
1