Spray Jets (Tt And Top Models); Waterfall (Tb Model); Whirlpool Jets (Tb Model); Notes For All Models - Jacuzzi frame Manuel D'utilisation Et D'entretien

Spray jets (TT and TOP models)

L
ocated on the sides of the showerhead, these thin, almost velvety
jets give your body a pleasant sensation of tonicity and vitality.
Adjust the water temperature as indicated in the "Water jet
functions - temperature adjustment" chapter.
Then turn the diverter (D) to the indicated symbol.

Waterfall (TB model)

T
he water, which is a true massage for the shoulder area, is lo-
cated above the panel that houses the brassware, near the roof.
Adjust the water temperature as indicated in the "Water jet
functions - temperature adjustment" chapter.
Then turn the diverter (D) to the indicated symbol.

Whirlpool jets (TB model)

L
ike a manual massage, these jets act on the lumbar and/or cervi-
cal area in a selective or simultaneous manner.
Adjust the water temperature as indicated in the "Water jet
functions - temperature adjustment" chapter.
Then turn the diverter (D) to the symbol:
- L, if you want to use the jets that act on the lumbar zone.
- C, if you want to use the jets that act on the cervical zone.
Each jet can be tilted by pressing the nozzle and moving it in
the desired direction.

Notes for all models

By positioning the diverter half way between the two sym-
bols, both functions can be used at the same time; obviously the
effect will be less strong, as the pressure will decrease.
After you have finished, in addition to closing the tap, re-
member also to turn the mixer knob to below a value of 38
°C and to position the diverter to the "water temperature
test" symbol (TT/TOP model) or "shower" (TB model).
The maximum temperature of the mixed water must
never exceed 45 °C!
48