Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Attaching Spool Assembly (Fig. B, C)
1. Install spindle plate
22
double D shaped retaining nut on the spindle sits inside
the base of the spindle plate.
2. Rotate the spindle plate until the hole
notch
in the housing. Insert the included rod
25
through the notch and into the hole, to prevent the
spindle from turning.
3. While holding the rod in place, thread the new spool
housing
10
with spool grip cover counterclockwise.
Securely tighten the new spool housing onto
the spindle.
Fig. B
24
Fig. C
Attaching Guard (Fig. D, E)
WARNING:
Damage or personal injury could result.
WARNING:
APPLIANCE WITHOUT GUARD FIRMLY IN PLACE.
onto the spindle
23
, so the
aligns with
24
25
22
23
23
Never remove the guard.
NEVER OPERATE
The guard must always be properly attached on the
appliance to protect the user.
1. Assemble the guard
2. Using a crosshead screwdriver, insert the 2 guard screws
15
and tighten securely.
nOTE: An extended coverage guard is available (sold
separately) for extra coverage if desired. Use CRAFTSMAN
replacement guard Part Number N636336.
Fig. D
5
15
Fig. E
10
15
Attaching the Auxiliary Handle (Fig. F)
1. Place the auxiliary handle
trimmer pole
2. Slide the bracket
bottom of the handle.
3. Thread the handle bolts
into the bracket from above.
4. Tighten the handle bolts. Ensure the handle is securely
attached by closing the handle clamp
5. To adjust the position of the auxiliary handle, open the
handle clamp and slide the handle up and down the
pole until it is in the desired location. Close the clamp to
lock the handle in place.
to the motor housing
9
4
onto the top of the upper
6
as shown in Figure F.
of the auxiliary handle onto the
30
31
through the handle and
29
English
.
5
9
.
7
Publicité
Table des Matières
