Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To accelerate the trimmer, push the speed control
switch
3
forward toward the auxillary handle
"HI" position. This mode is best to cut through heavier
growth and for applications that need higher RPM.
nOTE: When in "HI" mode, runtime will be decreased as
compared to when trimmer is in "LO" mode.
Trimming (Fig. I, J)
With the trimmer on, angle it and swing side to side as
shown in Figure I.
Maintain a minimum distance of 24" (610 mm) between the
guard and your feet as shown in Figure J.
Fig. I
Fig. J
WARNING:
roughly parallel with the ground (tilted no more
than 30º). This trimmer is not an edger. DO NOT
TILT the trimmer so that the string is spinning near
a right angle to the ground. Flying debris can cause
serious injury.
Bump Feed Trimmer Line Feed
Your trimmer uses 0.080" (2 mm) diameter diameter line
that is spiral-shaped with smooth round edges. Cutting line
will wear faster and require more feeding if the cutting is
done along sidewalks or other abrasive surfaces or heavier
weeds are being cut.
4
into the
Minimum
24" (610 mm)
Keep the rotating string
As you use the trimmer, the string will get shorter due
to wear. Gently bump the trimmer on the ground while
running at normal speed and the line will feed.
nOTE: Extending nylon line beyond the 13" (330 mm)
swath will negatively affect performance, runtime, and the
life of the trimmer due to potential of damaging motor.
Doing so may void the warranty.
Helpful Cutting Tips (Fig. M)
•
Use the tip of the string to do the cutting; do not force
string head into uncut grass.
•
Wire and picket fences cause extra string wear, even
breakage. Stone and brick walls, curbs, and wood may
wear string rapidly.
•
Do not allow spool cap
other surfaces.
•
In long growth, cut from the top down and do not
exceed 12" (305 mm) high.
•
Keep trimmer tilted toward the area being cut; this is
the best cutting area.
•
The trimmer cuts when passing the unit from the left to
right. This will avoid throwing debris at the operator.
•
Avoid trees and shrubs. Tree bark, wood moldings,
siding, and fence posts can easily be damaged by
the string.
Reloading the Cutting Line (Fig. K–M)
WARNING:
serious personal injury, turn unit off and
remove the battery pack before making any
adjustments or removing/installing attachments
or accessories, when replacing line, or prior to
cleaning. An accidental start-up can cause injury.
CAUTION:
replacement spools and line. Using any other
manufacturer's line can reduce performance, damage
the trimmer or cause personal injury.
Your trimmer uses 0.080" (2 mm) diameter line that is
spiral-shaped with smooth round edges. Do not use
other size lines. This can degrade performance, cause
damage to the unit or injury.
CAUTION:
the cutting line protrudes beyond the trimming blade,
cut it off so that it just reaches the blade.
Use only CRAFTSMAN replacement line.
1. Remove battery.
2. Cut a max of 20' (6 m) length of of 0.080" (2 mm)
trimmer line.
3. Align spool housing eyelets
the spool grip cover
20
4. Thread one end of the trimmer line through an eyelet.
Guide the line through to the second eyelet and
continue to pull the line through until there are equal
English
28
to drag on ground or
To reduce the risk of
Use only CRAFTSMAN
To avoid appliance damage, if
with the arrow
21
18
as shown in Figure K.
on
9
Publicité
Table des Matières
