Assembly Of Structure; Assembly Of Lower Rails - Trigano OSMOSE ANTHRACITE Notice De Montage Et Guide De Montage

9 - Assembly of Structure

To enable you to make sure that the distance and alignment are satisfactory, temporarily connect the
upper plates onto the main joists, using one single bolt. Lay-out the step stones without securing them,
and fit-on the lower rails.
YES

10 - Assembly of Lower Rails

If the pool is not positioned on a concrete slab, position a small slab measuring approximately 30 by
30 cm within the rounded parts at each point of connection of the lower rails. These slabs should be
positioned so that their upper faces are exactly at ground level.
Warning!
It is important that the entire length of the connection plate should lie on a flat slab. Using a
slab that is too short or failing to use a slab at all could render the installation unsatisfactory or
could cause the pool to collapse.
A
Check the spaces between the posts (side S)
and their verticality very carefully.
The levels between each one should also be
checked.
NO
Once alignment has been finished, make sure that
the diagonal distances are the same.
Once you have finished setting the positions, fill
the trenches with a little sand.
A
52 Notice N°880 107 Rev A