Installing The Step Stones And Border Parts - Trigano OSMOSE ANTHRACITE Notice De Montage Et Guide De Montage

Cut the surplus length of plastic section. Install the upper rails, which should be directly above the
lower rails, and fold-over the connecting plates and the upper plates over the rails without permanently
securing them.
You should remain in or near the pool until it contains 20 cm of water. Working from within, position
the sheet metal on the outline marked on the ground, by striking gentle blows at the base. At this
point, if the liner has been properly tensioned, you can permanently secure the upper plates and
connecting plates by tightening the 3 securing bolts.
Make cut-outs in the liner to enable you to install the skimmer and outlet before completely
filling the pool. (refer to section 14, "Filtration").

13 - Installing the Step Stones and Border Parts

The step stones should be positioned in a certain direction. The widest edge should be
towards the outside. The step stones should be positioned between the posts. Each end of a step
stone should be bolted to an upper plate or connecting plate.
It may be necessary to gently move the posts to the left or right in order to install the step stone. Only
tighten the bolts when they have all been laid in position.
Fit the border parts overlapping the ends of the step stones, centring them.
The narrow part of the border part should be located towards the interior of the pool.
:
IMPORTANT The cover pieces of the rounded and straight parts are different: the cover
pieces are wider along the straight parts.
2475
3472
2476
56 Notice N°880 107 Rev A