Star Progetti Heliosa Hi Design 77 Mode D'emploi page 14

BEFORE PROCEEDING WITH BULB REPLACEMENT, OPERATORS MUST:
1. FULLY DISCONNECT THE DEVICE FROM POWER SUPPLY AND MAKE SURE THE BULB IS COLD
2. NOT TOUCH THE BULB WITH THEIR BARE HANDS.
REPLACEMENT OF BULB
1. HELIOSA HI DESIGN 33
1. HELIOSA 77
3
3. TOGLIERE LE DUE COPERTURE LATERALI E LE DUE
TESTATE DELLA PARABOLA
REMOTE CONTROLLER – USE
START-UP
The functions of the remote control provided are as follows:
-turn on
-half-power control
-turn off
TO TURN ON:
point remote control at sensor of appliance, press POWER 100% button for 1 or 2 seconds. A green indicator will immediately
light up (confirming electrical start up). The full power regimen of the appliance is reached in approx. 30 seconds.
HALF-POWER CONTROL
for half-power, press POWER 50%
TO TURN OFF:
press OFF button
1
2. PER SOSTITUIRE IL BULBO, ESERCITARE UNA LEGGERA PRESSIONE
2. TO REPLACE THE BULB, PRESS GENTLY TOWARD THE RIGHT (THIS
VERSO DESTRA (LIBERANDO COSI' LA PARTE SINISTRA) E POI VERSO
RELEASES THE LEFT SIDE). THEN PRESS TOWARD THE LEFT.
SINISTRA.
3. TO FIT THE NEW BULB PROCEED IN THE REVERSE ORDER, MAKING SURE THAT THE
BULB ENDS CORRESPOND WITH THE BULB HOLDER CONTACTS.
2. SVITARE LE 4 VITI DEL RETRO
2
14