Yamaha CRX-E400 Mode D'emploi page 29

SYMPTOM
Play does not begin.
Play is delayed, or begins at the
wrong place.
CD synchronized recording or
Automatic recording function does
not work.
Sound "skips."
Sound "hums."
Noise from inside of the unit.
The remote control does not work.
TV functions strangely when the
remote control is being used.
CAUSE
The disc is damaged.
There is moisture on the laser pick-up.
The disc has been loaded upside down.
The disc is dirty.
The disc may be scratched or damaged.
The system cable is not connected securely.
The unit is being subjected to vibrations or
impacts.
The disc is dirty.
Improper cable connections.
The disc may be warped.
The batteries of the remote control are too
weak.
Remote control is too far away or is being
used at an incorrect angle.
Direct sunlight or lighting (of an inverter type
of fluorescent lamp, etc.) is striking the
remote control sensor of the unit.
Remote control is being used near TV set
with a remote control sensor.
ADDITIONAL INFORMATION
REMEDY
Check the disc carefully; replace it if necessary.
Wait 20 to 30 minutes after switching the unit ON
before trying to play a disc.
Reload the disc with the label side facing up.
Clean the disc.
Check the disc carefully; replace it if necessary.
Connect the system cable properly.
Relocate the unit.
Clean the disc.
Securely connect the audio cables. If the problem
persists, the cables may be defective.
Replace the disc.
Replace the batteries with new ones.
Use within 6 meters and 60 degree radius.
Change the position of the unit.
Relocate this unit away from the TV or cover the
TV's remote control sensor.
27