Listening To A Source; Basic Operations; Auto Standby Function - Yamaha CRX-E400 Mode D'emploi

Listening to a source

STANDBY/ON TREBLE
NATURAL SOUND
STANDBY/ON
DISPLAY MEMORY AUTO/MAN'L
TIMER
TIMER ADJ TIMER
BASS
PHONES
– +
PHONES BASS
POWER
1 2
1 2
4 5
4 5
7 8
7 8
0 +10
FREQ/RDS MODE – PTY SEEK – START
REP RANDOM
A B
TEXT/TIME
D
TAPE
DIRECTION
PRESET TUNER
MD CD
AUX
MD
REC/PAUSE
MODE DUBBING
SLEEP
VOLUME

BASIC OPERATIONS

VOLUME
VOLUME
STEREO RECEIVER RX–E400
PRESET/BAND PRESET/TUNING
MIN MAX
HOUR MIN
INPUT
TREBLE BALANCE
– +
L R
INPUT
BALANCE
POWER
3
3
6
6
9
+100
PROG
C
R. TIME
E
PRESET
TAPE
TAPE
REC/PAUSE
START
DISPLAY
VOLUME %/fi
1
Set the volume to "MIN" by turning VOLUME.
2
Turn on the power by pressing STANDBY/ON on
the front panel, or POWER on the remote control.
• Piano Craft series components that have correct
system connections made to RX-E400 can be
controlled to turn to the on or standby mode by
RX-E400. However, once the connected
components are turned to the standby mode with
their respective STANDBY/ON button, they
cannot be controlled by RX-E400 STANDBY/
ON button.
3
Select the desired input source by turning INPUT so
that the source appears on the display.
• When you operate the component connected to the
AUX terminal, turn INPUT to select AUX.
4
Play the source. (Refer to the owner's manual
supplied with each selected component.)
5
Adjust the volume level by turning VOLUME on the
front panel or pressing VOLUME %/fi on the remote
control.
6
If desired, adjust BASS, TREBLE, and BALANCE.
BASS: Turn this control clockwise to increase (or
counterclockwise to decrease) the low frequency
response.
TREBLE: Turn this control clockwise to increase (or
counterclockwise to decrease) the high frequency
response.
BALANCE: Adjust the balance of the output volume
from the left and right speakers to compensate for
sound imbalance caused by the speaker location or
listening room conditions.
When you use headphones
Connect the headphones to the PHONES jack. You can
listen to the sound to be output from the main speakers
through the headphones.
When you have finished using this
unit
Press STANDBY/ON on the front panel again or
POWER on the remote control to set this unit to the
standby mode.

Auto standby function

This unit will be put automatically into the standby mode
under the following conditions:
• A component connected with a system control cable is
selected as an input source.
• The component connected to this unit is in stop mode
and not operated for 30 minutes.
9