Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A self restoring thermocontact switches the motor
off in case of overheating. The motor is ready for
use when cooled off sufficiently.
Programming the remote control
The remote control for hood and hob are
preinstalled and ready for use. Only when te
remote control needs to be reprogrammed
(interaction with other controls)act as in the
following.
Determine the code used:
Simultaneously press on/off + the key with the
sun. The lamp flashes as well as the selected
code (there are 10 code options in total).
Change the code:
a. Simultaneously press on/off + the key with
the sun for 3 seconds until the lamp is flash-
ing. After this the lamp as well as the selected
code will flash. Repeat this step until you have
reached the required code (there are 10 code
options in total).
b. Simultaneously press + lamp of the roof cover
control until the second green LED is blinking.
c. Press the key with the sun on the remote con-
trol within 10 seconds to confirm the settings.
The cooker hood and the remote control are
now in line with each other.
Change the batteries:
• For changing the batteries unscrew the plastic
cover, remove the old batteries and insert the
new ones. Pay attention to the polarity marking
given in the battery compartment (figure 4).
• Empty batteries are not to be disposed of in the
household refuse, but they are to be handed in
as chemical waste.
NOVY key:
You can switch on the ambient lighting using the
NOVY key (figure 5).
Technical information:
- Power supply: (2xAAA) batteries
- Frequence: 433.92Mhz
- Numbre of codes: 10
- Worktemperature: 0-50°C
- Dimensions: 110 x 50 x 19mm
Maintenance
Maintenance of the grease filter
The hood contains one metal filter which should
be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 LEDs will start to
blink during 5 minutes, this indicates that the
grease filter has to be cleaned. When replacing
the cleaned filter, you have to reset the hood by
pushing the – button during 5 seconds . If you
don't reset, the LED lights will continu blinking.We
advise you to clean your filter twice a month for an
optimal operation.
Access to the filter
Take hold of the right and left side of the plate (a)
and pull down simultaneously.
Remove the filter (b) by taking hold of its hook and
pulling down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood.
Use a soft, wet cloth and a mild detergent to clean
the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.
EN 16
Publicité
Table des Matières
