Remote Control; Intouch; Operation Via Mobile Application - Novy Mood 7550 Mode D'emploi

You can change the colour temperature into warm light by
simultaneously pressing keys 5 and
for 4 seconds. Release both keys when the required colour
temperature has been reached.
After having switched off the mood mode, the last set value
will always be remembered. In this way your preference will
be used every time when switching on the hood.

2.4 Remote control

The remote control for hood is preinstalled and ready for use.


If the power is disconnected from the unit and
switched on again, wait 3 minutes before using
the remote control. This prevents the code from
being changed so that the unit does not res-
pond to the remote control or so that another
unit is not connected to the remote control.
Change the code on the remote control
If the set code disrupts other transmitters, another code
can be selected using the remote control. There are 10
different codes.
Determine the code used
Simultaneously press and
control flashes as many times as the selected code (there
are 10 code options in total).
Change the code
− First switch off the power supply of the hood. Do this
by deactivating and reactivating the on/off switch. The
set-up mode will now be active for 3 minutes. The new
code must be set up within these 3 min utes.
− Simultaneously press and
− The green light on the remote control flashes as many
times as the selected code. If another code is required
repeat this step again (1x flashing is code 1, 2x flashing
is code 2 etc. There are total of 10 codes).
− Press the key on the remote control within 10 seconds
to confirm the settings. The cooker hood and the remote
control are now in line with each other.
and holding them
. The lamp on the remote
and .

2.5 InTouch

The extraction hood has the InTouch function. If you
have an induction hob from Novy with InTouch, you can
operate the extraction hood from the hob. There is also
the option that the extraction hood can be operated with
a remote control.
Programming InTouch on the induction plate
The remote control must first work with the hood. If ne-
cessary, the remote control code can be changed, as
described in Section 2.5
− Connect the plate to the mains supply.
− Touch simultaneously the keys
plate until you hear a beep signal (prox. 7 sec.).
− The cooker plate now searches automatically for the
hood code.
− Wait until the cooker hood illumination begins to flashing
OR you hear a "click" sound when you have an extractor
hood without lighting (Be patient, this can betake a while).
− Does the light blink or you hear the "click" sound; press
immediately on any InTouch key or
on the induction hob.
− You will hear a "beep" signal to indicate the link between
the two devices.
Now you can operate the hood with the keys on the in-
duction plate.
You can find more information about using the InTouch
functions in the InTouch manual for the hob.

2.6 Operation via mobile application

This cooker hood can also be remotely controlled via a
mobile device. Is the Novy application on your mobile
device installed, then you can connect it to the cooker
hood. When the cooker hood is not connected to the
mobile device then the cooker hood can be operated in
a normal way via the remote control of the cooker hood
itself.
Set up
To use the Novy application for your cooker hood and
appliance installation you will need the following:
− The cooker hood must be connected to the mains power
supply and to be turned on.
− A smartphone or tablet with a current version of iOS or
Android operating system.
− Download the Novy application through your favourite
app store. Your cooker hood and mobile device should
be within range of each other
The application will guide you through the entire procedure.
Follow the clues in the application.
– 36 –
and on the induction
or or or