Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Lighting
Press key ④ to switch the lighting on or off. The
LED lighting has a soft on/soft off mode, which
means that the lighting will evenly go on and off.
When switching on the lighting, this will always
light up with full power and it can also be used
when the fan is off.
Dimming LED lighting
When the LED lighting has been switched on, it
can be dimmed by keeping key ④ pressed.
Programming the remote control
The remote control for hood and hob are
preinstalled and ready for use. Only when te
remote control needs to be reprogrammed
(interaction with other controls)act as in the
following.
Determine the code used:
Simultaneously press on/off + the key with the
sun. The lamp flashes as well as the selected
code (there are 10 code options in total).
Change the code:
a. Simultaneously press on/off + the key with
the sun for 3 seconds until the lamp is flash-
ing. After this the lamp as well as the selected
code will flash. Repeat this step until you have
reached the required code (there are 10 code
options in total).
b. Simultaneously press + lamp of the roof cover
control until the second green speed indicator
lamp is blinking.
c. Press the key with the sun on the remote con-
trol within 10 seconds to confirm the settings.
The cooker hood and the remote control are
now in line with each other.
Change the batteries:
• For changing the batteries unscrew the plastic
cover, remove the old batteries and insert the
new ones. Pay attention to the polarity marking
given in the battery compartment (figure 4).
• Empty batteries are not to be disposed of in
the household refuse, but they are to be hand-
ed in as chemical waste.
NOVY key:
You can switch on the ambient lighting using the
NOVY key (figure 5).
Technical information:
- Power supply: (2xAAA) batteries
- Frequence: 433.92Mhz
- Numbre of codes: 10
- Worktemperature: 0-50°C
- Dimensions: 110 x 50 x 19mm
Maintenance
Maintenance of the grease filter
The hood contains two metal filters which should
be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 speed indicator
lamps will start to blink during 5 minutes, this
indicates that the grease filter has to be cleaned.
When replacing the cleaned filter, you have to
reset the hood by pushing the – button during 5
seconds . If you don't reset, the speed indicator
lamps will continu blinking.We advise you to clean
your filter twice a month for an optimal operation.
Access to the filter
Take hold of the right and left side of the plate (a)
and pull down simultaneously.
Remove the filter (b) by taking hold of its hook
and pulling down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Recirculation (option)
If you have chosen for recirculation, please follow
the instructions below.
Cleaning indication:
The red speed indicator lamp will light up after
200 working hours (time to regenerate the used
carbon filter).
Follow the instructions below:
• Open the bottom plate.
EN 16
Publicité
Table des Matières
