General Safety Tips - brennenstuhl SOL 800 DE 3495 Notice D'utilisation

013417 Solar LED-Strahler SOL 800.qxp_013417 BA_Solar LED-Strahler SOL 800 19.03.18 10:20 Seite 10
Directions for use

GENERAL SAFETY TIPS

1. Do not use any other solar module than the one provided. Using another solar module
can cause injuries or damage to the light and termination of the warranty.
2. Lay the cable such that it is secured and cannot create any kind of hazard (e.g. hazard
of tripping). Discontinue use of the solar light if the cable is damaged or defective.
CLEANING
Keep the motion detector free of dust and deposits by occasionally cleaning it with a
damp cloth. Do not use any chemicals or abrasive agents to clean the device. Also, make
sure that the solar module is always free of dirt and deposits. A dirty solar cell cannot
completely charge the battery. This can cause premature aging in the battery and lead to
unreliable function in the device.
STORAGE
Follow these steps if you are going to store you light for more than two or three days
inside, in order to prevent damage to the battery:
1. Set the switch to the OFF-position.
2. Store the light and the solar module where the module can receive either sunlight or
indoor light every day. The battery needs light in order to retain its charge while
stored.
3. During long-term storage, the unit must be completely recharged every four months.
In order to preserve complete and proper performance, do not store it for long periods.
NOTE THE FOLLOWING TROUBLESHOOTING SOLUTIONS:
1. Problem: Light does not activate when there is motion in the monitored area.
Possible Solutions: Make sure that:
- The switch is in the "AUTO" position.
- The motion detector is set such that movements can be detected.
- The solar cell is aimed so that it can receive as much direct sunlight as possible
during the day.
- The battery's charge is not insufficient (charge for 3-4 sunny days with the switch set
to OFF).
2. Problem: Light flickers.
Possible Solution:
- Weak battery. Charge the solar light for 3-4 sunny days, during which the switch must
be set to OFF.
3. Problem: The light does not work after 8 hours of charging with the power supply.
Possible Solutions:
- Check to see if the power supply you're using complies with the prescribed
specifications.
- Have the battery voltage checked by a technician; it is possible that the battery has
been damaged and needs to be replaced.
10
Solar LED-Spot SOL 800 DE 3495