Parts List - brennenstuhl SOL 80 Notice D'utilisation

Installations- and Operating Instructions
Solar LED-Lamp SOL 80
Thank you for choosing our product. Before you use the product for the first time, you
need to familiarize yourself with the following operating instructions and safety warnings.
Only use the device as described and only for the areas of use that are indicated.
Keep these instructions. If the device is given to someone else, make sure these
instructions go with it.

PARTS LIST

1. Bracket
2. Power cable
3. Mounting screws
for solar module (4x)
4. Solar module
5. Main unit
6. LED-unit
7. Charger
8. Protective cap
9. Charge level display
(only when recharging through
the power supply)
10. Mounting screws for
main unit (2x)
11. Motion detector
12. AUTO / OFF switch
13. Control- light duration
14. Control- sensitivity
15. Control- responsiveness
INITIALLY CHARGING THE SOLAR POWERED LIGHT
Before you put the solar light into operation, it will need to be charged. You have two
options:
Charging via the Solar Module:
Connect the cable from the solar module with the main unit.
The AUTO / OFF-switch on the main unit must be set to OFF. Place the solar module in a
location where it will receive the maximum possible amount of direct sunlight.
Pay attention to the suggestions concerning a suitable mounting location in the next
section. Depending on the season, weather and position of the solar module, charging can
take up to 4 days before the lights can be put into operation.
4
3
6
10
11
1
2
5
12
TIME SENS LUX
13 14 15
8
7
9
7